Swann SW244-8ML Instrukcja Użytkownika Pobierz pdf (Strona 20)

 Setting to the motion alarm

 Setting to the ETC (Alarm Input method, RS-232).

Go to SETUP menu(6.TECHNICAL SETTING - MOTION ALARM OUTPUT) to do setting the motion

alarm.

Go to SETUP menu(6.TECHNICAL SETTING - ETC.) to do setting the alarm and RS-232 device.

Alarm(sensor) input method can be set either NO(NORMAL

OPEN) or NC(NORMAL CLOSE) in each channel.

NO(NORMAL OPEN) sensor method normally keeps “OFF”

state and converts to “ON” state when sensor is detected.

NC(NORMAL CLOSE) sensor method normally keeps “ON”

state and converts to “OFF” when sensor is detected.

Alarm output method can be set by High >>Low or

Low >> High in each channel.

High >> Low method converts output circuit from ON state

to OFF.

Low >> High method converts output circuit from OFF state

to ON.

For more information related to RS-232 setting, see its

manufacture’s manual.

When motion is detected in each camera channel during

active time, alarm output device operates for alarm

duration time.

For motion alarm output setting, see “6. TECHNICAL

SETTING - MOTION ALARM OUTPUT”

Select MOTION ALARM-ENABLE in each camera

channel to use alarm output function and set alarm output

channel, duration and active schedule.

OPERATION

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Brak uwag

Swann SW244-8ML Instrukcja Użytkownika Strona 20